Description
Instructions on building a Cable Cam for a small camera. A cable cam (or cablecam) allows you to take smooth moving shots, similar to dolly shots, but over uneven terrain. Professional cable cams are remote-controlled, can weigh hundreds (or thousands) of pounds, cost tons, and take hours or days to set up. This design fits in a backpack, was made of stuff I had laying around my house, and takes 15 minutes to set up. Before you begin, here are a few disclaimers. I have tested this design with a compact point-and-shoot camera. You may need to modify the design or materials to fit your particular model. A small difference in weight or size could disrupt the entire balance, rendering my design unusable. Also, note that the cablecam causes your camera to fly down a rope at relatively high speeds with a jolting stop at the end. I am not responsible for any damage that may occur. I have tested mine for over 75 shots with no mishaps so far, but no guarantees. Okay, now onto the materials. All PVC and fittings are 3/4 PVC Pipe 4 x 3 2 x 8 1 x 6 1 x 2.25 Fittings 4 x T-fittings 4 x 90 degree elbows 1 x end cap Hardware 1 x 1/4 by 1 bolt 10 x 1/4 by 1.25 fender washers 2 x pulleys (sorry, no clue what size they are) Cord/Rope 2 x 18 paracord 2 x 10-foot cords (paracord works here as well) 2 x 50-100 feet cable. Most of the video shot was done using paracord as the cable, but it stretches and is difficult to get taut. I have now replaced it with 5mm static climbing rope. Wire cable <b>...</b> |
